Visually solder hair dryer is similar to an ordinary household appliance, but it does not have anything to do with a hair dryer, if only because the difference in its temperature produced with other devices is very significant. Using a soldering hair dryer, you can dry the glue, melting the tips of synthetic ropes, solder SMD components and so on.
What you need to know?
A simple soldering iron, or soldering hair dryer, is a relatively new electric appliance, which makes it possible to warm up various metal parts in a quick time interval. If the device is high-quality assembly, the soldering hair dryer is suitable for both professionals and inexperienced welders. Also, the device is rather simple to use - function depends only on the quality of the soldering hair dryer, especially if it is assembled independently.
Soldering hair dryers are of different brands and sizes, but the general characteristics are approximately similar:
- Power is about 400-450 W.
- Consumes a power supply network about 230 volts.
- The diversity of temperatures ranges from 100C to 500 C.
- Diameter from 2 to 5 mm.
- Fan productivity in 30 liters per minute (this is its maximum).
Design device
The very function of the soldering hair dryer is to soften and melting the plastic and a different thin metal. To make it possible, there must be a good blowing of the heated spiral, since the heated air should transmit powerful energy in the form of heat to the material being processed.
The entire design of the assembled mechanism is:
- Heater (housing) having a shape of a thin cylinder.
- Supercharger, that is, either a pump or a suitable cooler.
- A pen.
- Switch.
Advanced users can install a temperature sensor or a pair of nozzles on a soldering device.
Soldering assembly with your own hands
For the production of such a device, any supported household appliances are suitable, you can also take the base of the steel tube. Do not take components from thin metals, like copper and aluminum - they will not fit. You should not forget that when fusing a soldering iron will become very massive and uncomfortable with long use, so a good solution will be a choice in favor of a special zharor-proof tissue.
Often, for assembling the soldering hair dryer, the most common used hairdryers use the most common used hair dryers, because it is in them that there are mica plates that they wear high degrees. Heating spirals must consist of soft nichrome wire. In no case do not choose a fechral for Spirals - he is too increasing.
Features of the assembly of the device
- The heater is located near the handle (the front sector of the soldering iron). This detail will allow the limitation of the length of the cord, which will be located inside the hair dryer, thereby lengthening it outside.
- The mineral tube from quartz is thoroughly wrapped with foil, this will reduce the heating temperature.
- Next, we assembled the element in the steel clip of the case and fix the cable outside the handle.
- In the same element insert a pre-harvested assembly. At the same time, the tube is carefully wrapped with a cord from asbestos. Thanks to this, the product itself will be located in the middle of the metal clip.
- Then you need to gently clamp the front output. After that, lay the hose in the handle intended for air supply.
It is very easy to make a soldering hair dryer, unless of course you have completed the assembly of the whole design. As materials you can use old hair dryers and soldering iron. The main thing is the heat resistance of the device and its ability to provide the desired power.
356
