How to insulate the walls from the inside in a private house. Methods of insulation of walls of the house from the inside. The article tells how to warm the walls from the inside in a private house

Very popular topic in autumn-winter Seasons - insulation of walls from the inside of the house. In order to warm up qualitatively, you need to get the necessary knowledge, because newcomers allow mistakes that in turn lead to the destruction of the walls by the accumulation of moisture or freezing. Frequent cases of incorrect wire laying, processing individual walls, since the electrician must be available for repair.

1
How to insulate the walls from the inside in private House - Materials

A huge advantage of insulating work from the inside of the house is a wide selection of seasonality. Let's literally work at any time of the year (and cold in winter, and hot summer). There are also minuses - this is a decrease in the residential area, the appearance of fungus in non-compliance with the working norms. Any repair can be useless In the absence of a good ventilation system.

Wall insulation from inside by foam

Features of good material: low, average cost, high quality, environmental safety for humans and for the surrounding nature. A good insulation is protected from rodents, such as mice, rats or pets, cats, dogs.

Wall insulation from inside PSB foam and extruded

Common Type of insulation. Easily withstands heavy loads.
Practically does not absorb moisture, quickly dries, incredible for rodents.
Used as good sound insulator. Weighs little, the fungus does not grow on it.
Withstand frost and heat. The average price value.
There are flaws - destroyed outdoors, under the sun, crumbs, burns.
PSB - material not pressed, often used to work with attic, atticgarages.
Extruded - pressed Polyfoam, convenient in home use, does not crumble, fades when burning.
In order to insulate the house from within the foam, you need to provide excellent ventilation of the room.

2
How to insulate the walls from the inside in private House - workflow

The walls are cleaned of dirt, dust. A primer is applied to the surface that protects the fungus from the propagation. Give suicide enough time to dry.

In Z. avisibility From the selected insulation, start trying on the pieces to the wall. Extruded is already sold with joints, you should play Tetris to understand what kind of piece start.
Prepared High-quality glue, which will be needed for planting foam sheets on the walls. For such purposes, an assembly foam is used, which is capable of withstanding heavy loads.
After the sheets of foam plastic are securely attached to the wall, you need to wait until the glue is completely drying, foam.
Next is made on the corners of each sheet, to further attach them dowels.

Umbrellas cannot go beyond the edges of the sheets. One sheet is taken five six pieces depending on the size of the sheet.
A holes in the foam drill holes in which umbrellas with plastic nails are inserted. Umbrellas are driven into the foam so as not to interfere with further working with the surface, but not very deeply.
There are joints between each sheet, they are stuck in the same insulation, or poured with mounting foam. After the frozen should be cut off the extra foam and slices of foam. Also, the foam is well bucked slabian.
Prepared reinforcing net. The material must be cut in such a way as to overlap the joints of the foam. Prepared the glue on which is attached reinforcing net. Each new layer is attached above After drying the previous one. At the very end, the entire surface of the reinforcement is sampled. Dried glue levels with shooting.

Further, the walls are ground and put on the final decorative finish (wallpaper, surface under painting).

Without insulation, the wall is very losing heat. The air will always find where the leak: leaky joints of concrete blocks, poor quality masonry, door, window cracks, improper ventilation. To determine what the site has a large heat loss at home, use a thermal imager. He will warm and cool areas of the house, so you can determine exactly what should be developed further.

For the purchase of building materials is important to know the reputation of distribution companies. This is done in order to protect themselves and their finances from low-quality products.