How to disassemble a vacuum cleaner?

There is a huge number of vacuum cleaners from various manufacturers on the market. However, in order to disassemble exactly your vacuum cleaner there are several common steps and rules that are suitable for any vacuum cleaner.

1

Case of vacuum cleaner

• The sealing grille is removed under the lid of the dust collector compartment. The lid itself is usually fixed with two screws or other connections. Unscrew the screws with a suitable screwdriver clockwise.
• When the sealing grille is removed, you should disconnect the control unit and the dust collector cover.
• The dust collector is either unscrewed or simply removed. It depends on the specific model and configuration of the vacuum cleaner.

2

Electric motor vacuum cleaner

• You can reach the motor of the vacuum cleaner by separating the body of the device from the base. Some models of vacuum cleaners can only be made after the secret screw is unscrewed, which is usually hidden in the handle.
• The engine of the vacuum cleaner is usually protected by a special gasket from the tissue attached at the inlet of the receiving hose. Periodically, the gasket must be removed and cleaned, and if necessary, replaced with a new one.
• Next, you need to disconnect the power wires from the engine. To do this, unwind the screw clamps.

3

Check engine parts for wear

• No matter how the manufacturer of the vacuum cleaner, the experienced masters first check the bearing pairs (upper and lower). For the most slightest signs of wear (cracks or irregularities), it is necessary to change components. It is also very important to check the brushes and anchor of the engine.
• When disassembling the engine, the first thing you need to remove the casing. This is done with a flat sparkling, planks or ruler. Since the housing is sufficiently firmly adjacent to the engine, you can sign a little on it to facilitate the disconnection process. The main thing about to count the strength and be extremely neat, since you can simply damage the casing.

• Next, you need to open access to the impeller, which is fixed on the built-in nuts. The nuts of this design are additionally fixed with glue, so the solvent is useful at this stage.
• Under the impeller there are 4 more screws that are fixed by the engine. They also need to promote them.
• Now that free access is open to the engine, you can proceed to check its performance. If some malfunctions are revealed, they must be eliminated, replacing the details failed.

The assembly of the engine and the vacuum cleaner is made in the reverse order.

Disassembly and assembly of a vacuum cleaner can perform any more or less technically competent person. The main thing to adhere to the rules and instructions described above and be neat.