How to disassemble electronic cigarette

Waipening fans know how not only to disassemble the electronic cigarette, but also it is easy to correct its standard malfunctions. Today we will tell you how to look into the "filling" of a popular accessory, without harm to its functioning.

1

How to Disassemble Electronic Cigarette - Tools

Most of the standard types of type have to have spinning parts connected by carvings. It does not even need a special skill. However, to look deeper, they may need special tools, including:

• tweezers to hold miniature cigarette details;
• cylindrical tube, preferably of plastic, whose diameter should be less than the device itself (it is useful to place the contents of a cigarette that is easy to damage directly by pressing the fingers);
• hammer with rubber nozzles, for safe disassembly of fragile parts;
• miniature, thin drill;
• pliers of suitable size;
• soldering iron - if something has to be fixed;
• needle.

When everything is ready, follow further.

2

We disassemble the electronic cigarette

The design of most Waip-devices is extremely simple. The device consists of three parts: the clemurizer (i.e. the cartridge with liquid), the battery and an atomizer, the last of which can be replaceable or not. Most often, this component comes out of order and for the sake of its repair, a cigarette is trying to disassemble. How to do it?

• We are promoting connected parts of the case. If any parts are twisted with the bolts - armed with a screwdriver and remove them.
• Using a tweezers, carefully remove the central contact, after which we move the wire.
• Remove the cartridge for the liquid and the battery. It should be noted that the battery is extremely recommended - it is better to replace it entirely. Incorrect handling of this detail can even provoke an explosion and damage your health.
• If the battery is not disconnected in the usual way, you can slightly bend and disperse a cigarette, or use the rubber tip hammer. Do not apply great effort, since the "filling" of the device may be quite fragile.
• Now we remove the lower plastic puck - just take out the tweezers, it must be fixed too tight.
• Separate mugs Methalates from the bottom of the device, we unwind the ribbon across the bridge.
• Remove the bridge itself, we remove the foam, which is located near the glass.
• Spiral seize tweezers, taking out with wires (from the battery side).
• If the wiring, which must be removed, is filled with glue, use the needle to clean the problem areas. In extreme cases, they can be separated by the pliers, and the holes, fully or partially filled with glue, clean using a thin drill.

Collect the electronic device exactly the opposite, carefully soldering the disconnected wires and replacing the details of the part new. Some inexpensive electronic cigarettes may not provide for "openings" and repair with the replacement of parts. They will have to be thrown by buying a similar or more expensive model.