Ten is without exaggerating the key part of any washing machine. This component is a metal tube inside which the helix is \u200b\u200blocated. Under the influence of electric current, heating occurs, which is necessary when using a washing machine in some modes.
It is worth understanding that over time the spiral is wears, which is why it is necessary to carry out repair work with a certain regularity. As a result, it turns out that the washing machine ceases to heat the water. At home, check the performance of Tan is easy.
How to check the TEN washing machine - the location of the Tan
The models of washing machines are now on the market, and the location of the Tan is almost always different.
- First you need to inspect the equipment from behind. If the back wall is large, then the TEN is most likely located in this part.
- If it is possible, you must position the washing machine to the side and look at the bottom exactly where the heating element is located.
- The most efficient way to search for a Tan is to dismantle the back cover. Washing machines have standard fasteners, so everything is simple enough.
How to check the TEN washing machine - carry out the calculation of resistance
For high-quality check, you need to navigate for some data related to the resistance of the Tan. Therefore, first you need to calculate normal resistance.
- U is the voltage that is fed to the heater. It is equal to the voltage of the household network - 200 V.
- P is the power of the heater. To accurately determine this parameter, it is necessary to analyze the reference literature supplied with the washing machine.
The basis will be based on the formula R \u003d U² / P, which allows you to obtain the resistance of the Tan in working condition. For example, if the heater power is 1800 W, we obtain the following solution to this problem:
R \u003d 220² / 1800 \u003d 26.8 Ohm.
It should be fixed this figure to compare after measurements.
How to check the Washing Machine Ten - "Corpon"
First of all, the washing machine is disconnected from the network, after which you can check.
To check, we need a regular multimeter. It must be translated into the measurement mode of resistance in OM-AH to the mark of 200 ohms. Multimeter ends should be applied to the heater terminals.
- On the screen of the multimeter should be highlighted, close to the calculated. It is almost never impossible to get the perfect value. If we calculated 26.8 ohms, the tests will show about 25-27 ohms.
- If the number 1 lights up on the display of the multimeter, then this suggests that there is a breakdown in Ten, so it is necessary to replace this component of the washing machine. There is no reason to repair.
- Approximately the same situation is also the case if the multimeter shows 0. This indicates a closure inside the tan, so the replacement of the heating element will not be avoided.
If the above test showed the necessary resistance, it still does not mean that everything is in order.
Tan case integrity check
It is possible that the malfunction consists in the dealer of the dielectric, which is located between the spiral and the Tan tube. The most dangerous is that the current can go to the washing machine body. A distinctive feature of such a breakdown is the presence of sparks under the washing machine.
To check the heater on the sample of the case, it is necessary to translate the multimeter to the backcraft mode, after which both the wires of the device can be interrupted. After that, the multimeter will emit a characteristic signal. Next, you need to touch by one end of the Multimeter of the TEN terminal, and the second is its housing. If the multimeter is published again, it is necessary to replace the housing.
352
