As practice shows, people actively using washing machines often face the inoperability of Tan. These heating elements are not the most reliable component, and you should navigate exactly how to check the Washing machine to check the TEN, so that if necessary it was possible to replace or repair.
Causes of the battery breakdown washing machine
- First of all, the reason may wage in the breakage of the tubular heating element, this can occur with a certain regularity if the conditions in which the equipment is not the most optimal.
- Flip due to rigid water. In those regions where water does not come from the nearest river, it may differ in a certain rigidity, so the raid on the agent will appear quite actively. At one moment, the volume of the plaque can be too vagatively affecting the heating element.
- Also, the breakdown of the Tan can cause both poor-quality household chemicals, thanks to which the thick layer of the plaque can also form.
First of all, a search is carried out, which lies in the dismantling of the rear wall of the washing machine, often the heating element is located there. However, in some cases, it is necessary to turn the washing machine on the side, and it is from there that there is access to the pen. Certain models allow you to unscrew the top cover of the washing machine, after which it is necessary to reject it and elementary to detect the TEN.
How to check the TEN washing machine - measurement of resistance
To carry out the most simple and reliable diagnostics in terms of the resulting results, it is necessary to measure resistance to the formula, and for this it will be necessary to pay attention to the formula: R \u003d U² / P, where R is the resistance, u is the voltage, and P is power. Of course, the voltage that the heater receives is 200 V. To learn the power of the Tan is also not the most difficult task, it is enough to use the documentation that comes complete with the equipment. It is important to note that most washing machines have a capacity of about 2000 W.
If you carry out the calculation, then the following result will be: 220 ² / 2000 \u003d 24.2 ohms.
How to check the tan washing machine multimeter
The value that we got higher is a resistance that corresponds to the normal operation of the Tan. For the test you need to use the multimeter. You must make sure that the washing machine is disabled from the network before starting the measurement. The device has 2 terminals that are made to the appropriate terminals on the age.
- If it turned out the value that corresponds to the above calculation, then this indicates the absence of problems with the Tan.
- The unit that appeared on the display of the multimeter says about the existing breakage inside the Tan.
- If the multimeter issued "zero", then this means that there is a short circuit. And in this case, and in the past, the heating element needs to be replaced.
Sometimes the problems associated with the heating of the Tan can manifest themselves irregularly, and after studying the heating element itself, cracks or other flaws can be detected. Of course, and in this case, the TEN must be replaced with a new one, since the instability in his work does not benefit anything good.
How to check the TEN of the washing machine - another way
There is another way to check the Tan, which is characterized by maximum simplicity. In this case, you need to turn on the washing machine and set the maximum possible heating during washing. If the electricity meter begins to spin quickly, it definitely speaks about the work of the Tan, otherwise this element simply does not function.
356
