If the purchased shirt turned out to be great for you, do not be upset. In the article, we will consider all the options with which you can take a shirt, sewing it on the figure. This process is quite laborious, you will need maximum attention and diligence.
Preparation for work
In the process of work, you will need such tools and materials:
- shirt;
- sewing machine;
- sharp scissors;
- tape measure;
- colored crayons or a piece of soap;
- needles and pins;
- threads in the tone shirt;
- eagle for sewing.
Fit silhouette
The easiest way to leave is slightly giving a shirt attached silhouette. Remove the shirt inside out, put it down (if you are swaying) or try on the one who will wear. Ibjects grab the side seams so that the shirt is perfectly sitting in the figure, and the movements were not apparent. Stop the side seams closer to the center. Remove the needles. If the shirt is slightly viable, try to deepen the side shades. Eashaw the launches evenly so that later everything looked symmetrically. Remove the unnecessary tissue and overtake the edges of the cuts.
If the shirt is great
In the case when you need to slightly reduce the volume and sew the sleeves, perform work in such a sequence:
- Preliminate with needles side seams of the backrest and transmission, as well as the elbow suture of the sleeves as far as it takes.
- Seat seams on the sides and then, smoothly crossing the armor, go to the elbow seam.
- Before cropping unnecessary material, try again.
- If everything suits you, the movements do not shine anything, and the shirt sits well on the figure, cut down too much and dress the edges.
Shirt wide
If the shirt turned out to be widely in the shoulders, you need to sew the entire side part, the armor and shoulder seam:
- Determine the measuring ruler, how many centimeters will continue to serve, and write down. The value should be the same for both sides.
- Mark the chalk formerly previously measured data, documen a smooth line along the entire side seam and the armor.
- The marked lines from both sides should be symmetrical.
- Then, write down the side and promotional seams, as well as the seam on the shoulder, do trust unnecessary.
- Connect the back and in front.
- On the side seam, fix with needles.
- Fold the middle of the sleeve with the center of the armor, secure them with each other.
- Note a needle sleeve and then neatly set on the typewriter.
- After the sleeve was shot, without ceasing to sew, smoothly move on the side seam of the transfer and the back.
- Damage all the edges of the cuts.
Crouching the sleeve
Perhaps you are not satisfied with the length of the sleeve on the shirt. To do this, you will need a fracture cuffs, cutting off an excess fabric at the bottom of the sleeve. Then the suture of the suture of the sleeve so that its width below coincides with the cuff length. Note the cuff and step by the usual line.
If the thing is new, preferably before you sew, wash it. Watch all the changes that you do, cutting the edges, were symmetrical. It is easy to sew a shirt, in the presence of elementary skills and maximum concentration of attention.
0
2052
